The test `test_mv_write_to_dead_node` currently uses a timeout of 60
seconds for remove_node, after it was increased from 30 seconds to fix
scylladb/scylladb#22953. Apparently it is still too low, and it was
observed to fail in debug mode.
Normally remove_node uses a default timeout of TOPOLOGY_TIMEOUT = 1000
seconds, but the test requires a timeout which is shorter than 5
minutes, because it is a regression test for an issue where MV updates
hold topology changes for more than 5 minutes, and we want to verify in
the test that the topology change completes in less than 5 minutes.
To resolve the issue, we set the test to skip in debug mode, because the
remove node operation is unpredictably slow, and we increase the timeout
to 180 seconds which is hopefully enough time for remove_node in
non-debug modes, and still sufficient to satisfy the test requirements.
Fixesscylladb/scylladb#22530Closesscylladb/scylladb#23833
5c1d24f983